Video Wall Image/Video Player logo

Video Wall Image/Video Player

Video Wall Video/Image player

This package allows you to play back videos and images on multiple screens. Build a giant video wall with ease.


Similar to other packages you can configure a playlist consisting of images and videos. It's recommended to use the Asset Browser for easy selection of assets.

In the Layout Configuration section you can set how many screens your video wall setup consists of. You can also tell the system if all monitors are rotated (clockwise). A setup with 3x1 screens rotated 90 degree might look like this:


Finally you must assign devices to each grid location. Click on Add Device, then select the grid position (x=1, y=1 is in the top left corner) and select the device that should display this location.

If you have multiple video walls that should display the same content, you can also assign multiple devices to the same grid position.


This package as experimental support for live streaming. Just enter a stream url and your device will play that stream instead of the configured playlist.

Since there is no communication across devices running a video wall setup, synchronization is tricky. Right now streaming really only works if you configure a RTP multicast stream. You can use the "Multicast Video Streamer" to generate such a stream from a connected camera module. Learn more about the package:

Multicast Video Streamer

Receives video from various sources and multicasts it to the local network as RTP stream

Standalone usage

Have a look at the included file to read more about how you can use this package outside of info-beamer hosted.

Version 6.3

  • Updated to also allow 4K images

Version 6.2

  • Prevent flickering when switching between two videos on some Pis

Version 6.1

  • Fixed streaming on Pi4
  • Added HEVC (4K!) video support

Version 6.0

  • Now runs on the Pi4

Version 5.0

  • Fixed playback problems for files with .jpeg/.mkv extension. The package now uses the backend supplied file type instead of using the asset's file extension.

Version 4.0

  • Fixed problem when switching between setups with explicitly set screen coordinates to one using defaults.
  • Playback of video is now seamless. Note that you can't mix setups using this new version with setups using a previous version.

Version 3.0

  • Added support for multicast streaming.

Want to run Video Wall Image/Video Player on your Raspberry Pi?

This package is ready to run on your Raspberry Pi using hosted. Easily manage unlimited number of Raspberry Pi devices and centrally configure and run visualizations like this on them. is a prepaid service. You only pay for the resources you are using. No long term commitment, no hidden fees. Learn more...

Compatible devices

pi-1 pi-2 pi-3 pi-4 pi-cm1 pi-cm3 pi-cm4 pi-zero pi-zero-2

Compatible packages

This package can be extended by importing the following packages as well. You can then add the following packages as a child package of Video Wall Image/Video Player to get additional features not included in Video Wall Image/Video Player itself.

Power Saver

Powers down the screen at configurable times. Add to any of your Setups.

Offline support

Maybe This package might work offline: Package provides no offline support information. Also check the information above.

Source code for this package shows you the full source code of this package so you can freely modify it if you want.